- ページ 5

DJ機材 digico SD7のPDF テクニカル・ノートをオンラインで閲覧またはダウンロードできます。digico SD7 11 ページ。 Replacing and cleaning faders
digico SD7 にも：マニュアル (9 ページ)

TN198 Page 5 of 11

Slide out engine PCB taking care of power connector. Unplug this connector when accessible.

The Engine Board should now slide completely out from the Chassis.

Place the Engine Tray on a flat surface with the BNC connectors furthest away from you.

The Optocore Board installs onto the Engine Board on the edge closest to you, next to the Power

connectors.

Ensure the connector is clean of dust and fit optical card :

Lay the Optocore Board in place, and once you are sure the connector alignment is correct, apply

pressure to the Optocore Board. You should apply the pressure to the area above the mating

connector. You will have to apply a reasonable amount of pressure, and the board will click into

place. Apply the pressure slowly and firmly.

Once the Optocore card is seated, secure it with the four screws provided, using the shakeproof

washers included with the kit.

TN198.doc\