digico SD7 기술 노트 - 페이지 5

{카테고리_이름} digico SD7에 대한 기술 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. digico SD7 11 페이지. Replacing and cleaning faders
digico SD7에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)

TN198 Page 5 of 11

Slide out engine PCB taking care of power connector. Unplug this connector when accessible.

The Engine Board should now slide completely out from the Chassis.

Place the Engine Tray on a flat surface with the BNC connectors furthest away from you.

The Optocore Board installs onto the Engine Board on the edge closest to you, next to the Power

connectors.

Ensure the connector is clean of dust and fit optical card :

Lay the Optocore Board in place, and once you are sure the connector alignment is correct, apply

pressure to the Optocore Board. You should apply the pressure to the area above the mating

connector. You will have to apply a reasonable amount of pressure, and the board will click into

place. Apply the pressure slowly and firmly.

Once the Optocore card is seated, secure it with the four screws provided, using the shakeproof

washers included with the kit.

TN198.doc\