digico SD7 기술 노트 - 페이지 6

{카테고리_이름} digico SD7에 대한 기술 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. digico SD7 11 페이지. Replacing and cleaning faders
digico SD7에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)

TN198 Page 6 of 11

The image below shows the Engine with the Optocore Board fitted.

The Following Connections now need to be made :

1 x Serial Connection from Optocore Board to PC

2 x Optical Fibre Connections from Optocore Board to Rear Panel of Engine*

* If you have ordered a 2 Loop Upgrade Kit, you will be provided with 4 HMA-LC Fibre Cables

Note that the network (RJ45 / Cat 5 connections) are not implemented at this time.

No RJ45 cables need to be connected.

Install Ribbon cable provided to connect between the Upper serial port (COM1) of the PC and the

10 way header on the optical card. It is easiest to fit the PC end of the cable first. When connected,

secure with the hex head bolts provided.

TN198.doc\