ページを印刷する
5. Install Tubing Bracket - 6 1/2" from right end of printer opening – See photo
The 6 1/2" is not from the outside of the printer, but from the inside opening of
the housing to the center of the bracket. Use an alcohol swab to clean the plastic
before attaching the bracket. Once it goes down, it is there to stay, so don't put it
in the wrong spot.
screwdriver and twist it under the bracket.
Note: If you have a refurbished 1160 with a housing that does not look like the one
above, use the bracket with the 45 degree bend instead of the long flat bracket.
6. Prepare Cartridges for Installation
Put some newspaper or paper towels in front of your printer.
Do not remove foil pull tabs from top of cartridges.
Insert the cartridges into the cartridge holder. Make sure the black felt pads are
on the cartridges. There should be 2 on the black cartridge and 2 on the color
cartridge. When you insert the cartridges be careful that the felt pads do not
come off or change position. You will have to insert the cartridge slowly to get a
nice tight fit. Make sure the cartridges are down all the way and seated firmly on
the bottom of the cartridge holder. These felt pads will prevent the cartridge
from coming loose or from being pulled out by the tension on the tubes.
Do not lift the cartridges off the posts or out of the cartridge holder once
they are down. This will introduce a large air pocket into the print heads and
may prevent the printer from working properly.
S a v e
M o n e y
MIS Associates Inc
http://www.inksupply.com
This is important.
If you have to remove it, use a wide blade
a n d
I m p r o v e
2901 Auburn Rd
Fax: 248-289-6013
This is important.
This is very important.
Y o u r
Auburn Hills, MI 48326
Email: [email protected]
P r i n t i n g
800-445-8296