- ページ 7

プリンター Epson 1430 CFSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Epson 1430 CFS 10 ページ。

Step 10:

Verify, from Front to Back the bottle order is as follows;

Cyan - Magenta - Lt. Magenta - Lt. Cyan - Black - Yellow

Next, split the excess tubing back to the right most Beige Clip.

Route the front most tube to the Cyan Bottle and using the

scissors, snip the tuba and plug it onto the Cyan Bottle fitting.

Repeat for the remaining tubes. The end result should look like

Fig. 10.

Note: The tubing should route cleanly into the bottle with our

being pulled tight, but also should not be loose enough to

allow the tubes to sag.

Step 11:

Attach a Bottom Fill Adapter (MIS-BADP) to each of the 10cc

Syringes (MIS-Syringe).

Remove the CFS Assembly from the printer carriage and flip it

upside down.

Using the 10cc Syringe draw 20cc's of air from the Cyan

Cartridge. This will fill the cartridge with ink, but should leave

a 1/2" - 1/4" gap of air in the cartridge. Repeat on the

remaining cartridges using a clean syringe on each cartridge. It

may be helpful to mark the color position on each of the

syringes to keep them organized.

Note: The air gap is critical to proper CFS function. Overfilling

the cartridge can damage the CFS unit or printer.

After filling all six cartridges, flip the CFS right side up and,

starting with the Cyan Cartridge, use the 10cc syringe to draw

2cc's of ink from the bottom of the cartridge. Again, it is

important to use the same syringe that was used to prime the

Cyan Cartridge. Repeat with the remaining cartridges.

S a v e

M o n e y

MIS Associates Inc

http://www.inksupply.com

a n d

I m p r o v e

2901 Auburn Rd.

Auburn Hills, MI 48326

Fax: 248-289-6013

Fig. 10

Fig. 11-1

Fig. 11-2

Y o u r

P r i n t i n g

800-445-8296