Epson 1430 CFS Manual de instruções de instalação - Página 7

Procurar online ou descarregar pdf Manual de instruções de instalação para Impressora Epson 1430 CFS. Epson 1430 CFS 10 páginas.

Epson 1430 CFS Manual de instruções de instalação
Step 10:
Verify, from Front to Back the bottle order is as follows;
Cyan - Magenta - Lt. Magenta - Lt. Cyan - Black - Yellow
Next, split the excess tubing back to the right most Beige Clip.
Route the front most tube to the Cyan Bottle and using the
scissors, snip the tuba and plug it onto the Cyan Bottle fitting.
Repeat for the remaining tubes. The end result should look like
Fig. 10.
Note: The tubing should route cleanly into the bottle with our
being pulled tight, but also should not be loose enough to
allow the tubes to sag.
Step 11:
Attach a Bottom Fill Adapter (MIS-BADP) to each of the 10cc
Syringes (MIS-Syringe).
Remove the CFS Assembly from the printer carriage and flip it
upside down.
Using the 10cc Syringe draw 20cc's of air from the Cyan
Cartridge. This will fill the cartridge with ink, but should leave
a 1/2" - 1/4" gap of air in the cartridge. Repeat on the
remaining cartridges using a clean syringe on each cartridge. It
may be helpful to mark the color position on each of the
syringes to keep them organized.
Note: The air gap is critical to proper CFS function. Overfilling
the cartridge can damage the CFS unit or printer.
After filling all six cartridges, flip the CFS right side up and,
starting with the Cyan Cartridge, use the 10cc syringe to draw
2cc's of ink from the bottom of the cartridge. Again, it is
important to use the same syringe that was used to prime the
Cyan Cartridge. Repeat with the remaining cartridges.
S a v e
M o n e y
MIS Associates Inc
http://www.inksupply.com
a n d
I m p r o v e
2901 Auburn Rd.
Auburn Hills, MI 48326
Fax: 248-289-6013
Fig. 10
Fig. 11-1
Fig. 11-2
Y o u r
P r i n t i n g
800-445-8296