- ページ 2

カーエレクトロニクス Axxess ASWC-TOY-LEXのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Axxess ASWC-TOY-LEX 8 ページ。 Axxess steering wheel control interface toyota/lexus select vehicles 1999-2009

ページを印刷する

Into the vehicle

With the key in the off position:

1. Connect the Black wire of the ASWC-TOY-LEX to ground.

2. Connect the (2) Red wires of the ASWC-TOY-LEX to accessory power.

3. For all vehicles EXCEPT the Lexus SC430, connect ONLY the 12-pin connector to the

mating connector in the vehicle. The 6-pin connector on the ASWC-TOY-LEX harness

WILL NOT be used in the application.

4. For the 2002-2005 Lexus SC430, connect ONLY the 6-pin connector to the mating

connector in the vehicle. The 12-pin connector on the ASWC-TOY-LEX harness WILL

NOT be used in the application.

Note: Disregard the 12-pin connector in the vehicle.

5. For the 2006-2009 Lexus SC430, connect BOTH the 6-pin and 12-pin connectors to

the mating connectors in the vehicle.

To the radio

1. For the radios below, connect the included female 3.5mm connector with the Brown

and Brown/White wires into the male 3.5mm connector of the ASWC-TOY-LEX

harness.

• For Eclipse radios: Connect the Eclipse steering wheel control wires (normally

Brown and Brown/Black) to the Brown and Brown/White wires of the ASWC-

TOY-LEX. Brown of the ASWC-TOY-LEX goes to the Brown/Black of the Eclipse and

Brown/White of the ASWC-TOY-LEX goes to the Brown of the Eclipse.

CONNECTIONS TO BE MADE

2. For Parrot Asteroid Smart or Tablet: Connect the ASWC-TOY-LEX male 3.5mm jack

3. For XITE radios: Connect the steering wheel control SWC-2 wire from the radio to

4. For all other radios: Connect the 3.5mm jack of the ASWC-TOY-LEX into the jack on

• For Metra OE: Connect the SWC Key 1 wire (Gray) to the Brown wire of the

ASWC-TOY-LEX. Isolate and tape the Brown/White wire, it will not be used.

• For Kenwood or select JVC's with a Blue/Yellow steering wheel control wire:

Connect the Kenwood/JVC steering wheel control wire to the Brown wire of the

ASWC-TOY-LEX. Isolate and tape the Brown/White wire, it will not be used.

Note: Some of the newer Kenwood radios will auto detect as a JVC. If this is

the case, use a 12k ohm resistor in line between the Blue/Yellow and Brown

wire of the female 3.5mm jack during programming only (remove resistor once

programmed).

into the AX-SWC-PARROT (sold separately) female 3.5mm jack and plug the 4-pin

end into the corresponding SWC plug on the radio.

Note: AX-SWC-PARROT required (sold separately) and radio MUST BE updated to

rev 2.1.4 or higher.

the Brown wire of the ASWC-TOY-LEX.

the aftermarket radio designated for an external steering wheel control interface.

Please refer to the aftermarket radios manual if in doubt as to where the 3.5mm

jack goes into.