- ページ 4

カーエレクトロニクス Axxess RFASWCのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Axxess RFASWC 12 ページ。 Wireless swc universal add-on
Axxess RFASWC にも：取付説明書 (12 ページ)

Note: The Black/Yellow wire is the antenna for the RFASWC.

Do not cut or lengthen this wire; leave it as-is.

Into vehicle

With the key in the off position:

1) Connect the Black wire of the RFASWC to the ground. You may use the same

grounding point as the aftermarket radio; but it is highly recommended to

ground the RFASWC to the chassis of the vehicle, by itself.

2) Connect the Red wire of the RFASWC to the 12-volt accessory wire.

Into radio

1) For the radios listed below, plug the included female 3.5mm adapter

(with the Brown and Brown/White wires) into the male 3.5mm connector of the

RFASWC harness.

a. For Eclipse radios: Connect the Eclipse steering wheel control wires

(normally Brown and Brown/Black) to the Brown and Brown/White wires

of the RFASWC. The Brown of the RFASWC goes to the Brown/Black of the

Eclipse and Brown/White of the RFASWC goes to the Brown of the Eclipse.

b. For Metra OE radios: Connect the steering wheel control Key 1 wire (Gray)

to the Brown wire of the RFASWC. Isolate and tape the Brown/White Wire, it

will not be used.

c. For Kenwood, or select JVC's with a Blue/Yellow steering wheel

control wire: Connect the Kenwood/JVC steering wheel control wire to the

RFASWC Installation

2) For Parrot Asteroid Smart or Tablets: Connect the 3.5mm jack of the RFASWC

3) For all other radios: Plug in the male 3.5mm connector of the RFASWC into the

Brown wire of the RFASWC. Isolate and tape off the Brown/White wire, it

will not be used.

Note: Some of the newer Kenwood radios will auto detect as a JVC. If this

is the case, either (a) use the included 12k ohm resistor in-line between

the Blue/Yellow and Brown wire of the female 3.5mm jack only during

programming (once programmed remove the resistor) or (b) you can

manually set the radio type, refer to the Changing Radio Type.

d. For XITE radios: Connect the steering wheel control SWC-2 wire from the

radio to the Brown wire of the RFASWC. Isolate and tape the Brown/White

wire, it will not be used.

into the female 3.5mm jack of the AX-SWC-PARROT (sold separately). Then plug

the 4-pin male harness into the corresponding steering wheel control female

harness in the radio.

Note: AX-SWC-PARROT is required (sold separately) and the radio must be

updated to rev. 2.1.4 or higher. Additionally, the RFASWC must be updated to the

most recent software available.

back of the aftermarket radio, designated for an external steering wheel control

interface. Please refer to the aftermarket radios manual if in doubt where the

3.5mm connector of the RFASWC goes into.