Axxess RFASWC Handleiding voor installatie-instructies - Pagina 4
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Axxess RFASWC. Axxess RFASWC 12 pagina's. Wireless swc universal add-on
Ook voor Axxess RFASWC: Handleiding voor installatie-instructies (12 pagina's)
Pagina afdrukken
Note: The Black/Yellow wire is the antenna for the RFASWC.
Do not cut or lengthen this wire; leave it as-is.
Into vehicle
With the key in the off position:
1) Connect the Black wire of the RFASWC to the ground. You may use the same
grounding point as the aftermarket radio; but it is highly recommended to
ground the RFASWC to the chassis of the vehicle, by itself.
2) Connect the Red wire of the RFASWC to the 12-volt accessory wire.
Into radio
1) For the radios listed below, plug the included female 3.5mm adapter
(with the Brown and Brown/White wires) into the male 3.5mm connector of the
RFASWC harness.
a. For Eclipse radios: Connect the Eclipse steering wheel control wires
(normally Brown and Brown/Black) to the Brown and Brown/White wires
of the RFASWC. The Brown of the RFASWC goes to the Brown/Black of the
Eclipse and Brown/White of the RFASWC goes to the Brown of the Eclipse.
b. For Metra OE radios: Connect the steering wheel control Key 1 wire (Gray)
to the Brown wire of the RFASWC. Isolate and tape the Brown/White Wire, it
will not be used.
c. For Kenwood, or select JVC's with a Blue/Yellow steering wheel
control wire: Connect the Kenwood/JVC steering wheel control wire to the
RFASWC Installation
Connections to be Made
2) For Parrot Asteroid Smart or Tablets: Connect the 3.5mm jack of the RFASWC
3) For all other radios: Plug in the male 3.5mm connector of the RFASWC into the
4
Brown wire of the RFASWC. Isolate and tape off the Brown/White wire, it
will not be used.
Note: Some of the newer Kenwood radios will auto detect as a JVC. If this
is the case, either (a) use the included 12k ohm resistor in-line between
the Blue/Yellow and Brown wire of the female 3.5mm jack only during
programming (once programmed remove the resistor) or (b) you can
manually set the radio type, refer to the Changing Radio Type.
d. For XITE radios: Connect the steering wheel control SWC-2 wire from the
radio to the Brown wire of the RFASWC. Isolate and tape the Brown/White
wire, it will not be used.
into the female 3.5mm jack of the AX-SWC-PARROT (sold separately). Then plug
the 4-pin male harness into the corresponding steering wheel control female
harness in the radio.
Note: AX-SWC-PARROT is required (sold separately) and the radio must be
updated to rev. 2.1.4 or higher. Additionally, the RFASWC must be updated to the
most recent software available.
back of the aftermarket radio, designated for an external steering wheel control
interface. Please refer to the aftermarket radios manual if in doubt where the
3.5mm connector of the RFASWC goes into.