- ページ 6

試験装置 CIRCUIT DESIGN WA-TBT-03SのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。CIRCUIT DESIGN WA-TBT-03S 13 ページ。

CONNECTING THE MIC

You may use a 2 or 3-line condenser microphone or dynamic microphone. You must use 3.5mm

mono plug only.

A condenser microphone requires a power supply (phantom supply) to drive it. The WA-TBT-03S

board is able to supply this phantom power via the connector.

There are various microphone types available on the market, so please consult the microphone

datasheets and if necessary add solder to the three jumper locations as shown below. These

jumpers are labeled on the WA-TBT-03S board as 3JP, 2JP and AF JP.

Two / Three wire condenser microphone

Apply solder to 3JP and AF JP

OG_WA-TB-03S_v10e

Dynamic microphone or audio signal

Apply solder to AF JP as shown below

OPERATION GUIDE

Circuit Design, Inc