CIRCUIT DESIGN WA-TBT-03S 운영 매뉴얼 - 페이지 6

{카테고리_이름} CIRCUIT DESIGN WA-TBT-03S에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CIRCUIT DESIGN WA-TBT-03S 13 페이지.

CONNECTING THE MIC

You may use a 2 or 3-line condenser microphone or dynamic microphone. You must use 3.5mm

mono plug only.

A condenser microphone requires a power supply (phantom supply) to drive it. The WA-TBT-03S

board is able to supply this phantom power via the connector.

There are various microphone types available on the market, so please consult the microphone

datasheets and if necessary add solder to the three jumper locations as shown below. These

jumpers are labeled on the WA-TBT-03S board as 3JP, 2JP and AF JP.

Two / Three wire condenser microphone

Apply solder to 3JP and AF JP

OG_WA-TB-03S_v10e

Dynamic microphone or audio signal

Apply solder to AF JP as shown below

OPERATION GUIDE

Circuit Design, Inc