- ページ 9
プリンター Epson C11C605001 - DFX 9000 B/W Dot-matrix PrinterのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Epson C11C605001 - DFX 9000 B/W Dot-matrix Printer 28 ページ。 User guide - remote configuration manager
Epson C11C605001 - DFX 9000 B/W Dot-matrix Printer にも： 仕様 (2 ページ), ファームウェアのアップデート (1 ページ), ユーザーマニュアル (15 ページ)
ページを印刷する
Chapter 2
Loading Paper
Using the Two-Tractor System
Your printer can load paper from a front tractor and a rear tractor. Be sure to
leave enough room around the printer for the two stacks of fresh paper and for
the printed stack. Align your paper supply so the paper feeds smoothly into the
printer.
front tractor
rear tractor
Place the paper supply lower than the printer to avoid a paper jam. Make sure
that your stack of printed pages does not interfere with the rear tractor's paper
supply.
Supported Paper Types and Sizes
You can use the following types of continuous paper with either tractor:
Single-sheet
Multi-part
Labels
Continuous forms with labels
Overlapping multi-part forms
both tractors
You can print on continuous paper from 3 inches (76.2 mm) to 16.5 inches
(419.1 mm) wide. Your printer senses the paper width automatically.
The printer automatically adjusts to the thickness of the paper loaded when the
platen gap setting is set to
in SelecType mode. See "Using SelecType
Auto
Mode" on page 18 for details.
Note:
Make sure your paper matches the specifications described in the on-screen
Reference Guide.
When the optional perforation cutter (part number C81507X) is installed, the
printable width is from 4 inches (101.6 mm) to 16 inches (406.4 mm).
Loading Paper On the Front Tractor
1.
Lift up the front cover until it locks in place.
2.
Release the right and left sprockets by pulling the lock levers down.
sprocket lock lever
Loading Paper 9