ページを印刷するInstallation Summary
The installation must comply with all plumbing and electrical codes. A licensed plumber
should complete the plumbing of the spa.
Note: Failure to comply with federal, state or local codes and ordinances will result in
the warranty being considered null and void.
Select a level location where the floor is capable of supporting the weight of an occupied
spa. For the seat back to fully recline, the spa base must be placed a minimum of 16-20
inches from the wall.
Connect the water supply lines with cold and hot inputs.
Connection: Cold
Connect the floor drain connection to the P-trap (if you are using a wall drain you will
need to install a discharge pump).
Connection: P-trap 1½-inch drain pipe
Place the drain plug into the drain from the top (the drain plug may need to be adjusted
so that it forms a tight seal around the drain).
Install the faucet handle by inserting it into the faucet in front with the red and blue
indicator facing up. Then, tighten the lock screw with a small flathead screwdriver.
Attach the sprayer to the sprayer hose (be sure to cut the zip tie around the sprayer
hose).
Plug the power cord into a GFCI outlet.
Specifications
Shipping Dimension & Weight
Net Dimension & Weight
Capacity of Tub
Switch
Power Source
Plumbing Source
Warranty
½ NPT
Hot
½ NPT
Pedicure Spa & Massage Chair
Pedicure Spa & Massage Chair
Dedicated 15Amp Wall Outlet Required
Pipeless Jet motor
Discharge Pump (Optional)
Massage System
Hot Water
Cold Water
Drain
1 Year (See Warranty for covered parts)
60"L x 40"W x 48"H
56"L x 23.5"W x 56"H
4.5 Gallons (approximate)
On/Off Air Activated Switch
120V, 0.4 A, 60Hz
115V, 3.2 A. 60Hz
120V, 60Hz
½" (fitting provided)
½" (fitting provided)
3/4" or 1 ½ " (See Plumbing Instructions)
250 lbs.
194 lbs.