- ページ 2

コンピュータ・ハードウェア Digilent chipKIT Network ShieldのPDF リファレンスマニュアルとユーザーガイドをオンラインで閲覧またはダウンロードできます。Digilent chipKIT Network Shield 11 ページ。 Chipkit network shield board
Digilent chipKIT Network Shield にも：リファレンス・マニュアル (11 ページ)

ページを印刷する

chipKIT Network Shield Reference Manual

chipKIT Network Shield Hardware Overview

The Network Shield has the following hardware features:

1) USB Connectors

The connector on the top of the board is a standard USB A type receptacle. This is used

when the Max32/Network shield is used as a USB host. Immediately below this connector

is a USB Micro-AB connector. Tis connector is used when the Max32/Network Shield is

used as a USB device, or when using it as an On-The-Go (OTG) device.

2) Ethernet Connector with Integral Magnetics

This connector is used to connect the Max32/Network Shield to an Ethernet network..

3) JP4 – USB Host Connector Selection

When the Max32/Network Shield is used as a USB host, this jumper is used to select

which USB connector is being used.

4) J17 – Power Pass-through Connector

This connector passes the power connector from the Max32 through the Network Shield

board, and powers the Network Shield from the Max32.

5) J9 & J12 – Analog Signal Pass-Through Connectors

These connectors pass the analog input pins on the Max32 through the Network Shield

board.

www.digilentinc.com

page 2 of 11