Digilent chipKIT Network Shield Referentiehandleiding en gebruikershandleiding - Pagina 2
Blader online of download pdf Referentiehandleiding en gebruikershandleiding voor {categorie_naam} Digilent chipKIT Network Shield. Digilent chipKIT Network Shield 11 pagina's. Chipkit network shield board
Ook voor Digilent chipKIT Network Shield: Referentiehandleiding (11 pagina's)
Pagina afdrukkenchipKIT Network Shield Reference Manual
chipKIT Network Shield Hardware Overview
The Network Shield has the following hardware features:
1) USB Connectors
The connector on the top of the board is a standard USB A type receptacle. This is used
when the Max32/Network shield is used as a USB host. Immediately below this connector
is a USB Micro-AB connector. Tis connector is used when the Max32/Network Shield is
used as a USB device, or when using it as an On-The-Go (OTG) device.
2) Ethernet Connector with Integral Magnetics
This connector is used to connect the Max32/Network Shield to an Ethernet network..
3) JP4 – USB Host Connector Selection
When the Max32/Network Shield is used as a USB host, this jumper is used to select
which USB connector is being used.
4) J17 – Power Pass-through Connector
This connector passes the power connector from the Max32 through the Network Shield
board, and powers the Network Shield from the Max32.
5) J9 & J12 – Analog Signal Pass-Through Connectors
These connectors pass the analog input pins on the Max32 through the Network Shield
board.
www.digilentinc.com
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
page 2 of 11