- ページ 11

スイッチ Cisco 2960-CのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2960-C 37 ページ。
Cisco 2960-C にも：スタートマニュアル (25 ページ)

Chapter 2

Switch Installation

Locate the screw template. The template is used to align the mounting screw holes.

Step 1

Note

Position the screw template so that the two side-by-side slots face toward the floor, as shown in

Step 2

Figure

For the best support of the switch and cables, make sure that you attach the switch securely to a wall stud

or to a firmly attached plywood mounting backboard.

Peel the adhesive strip off the bottom of the screw template.

Step 3

Attach the screw template to the wall.

Step 4

Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw

Step 5

template slots.

Insert three screws in the slots on the screw template, and tighten until they touch the top of the

Step 6

screw template.

Remove the screw template from the wall.

Step 7

Figure 2-5

1.77 in. (4.49 cm)

3.72 in. (9.44 cm)

3.62 in. (9.19 cm)

OL-23803-02

Figure 2-5

shows the measurements for the location of the screws on the switch.

2-6.

Location of the Mounting Holes on the Switch

2.67 in. (6.78)

2.46. in. (6.24)

Switch

Catalyst 3560-C and 2960-C Switch Hardware Installation Guide

Mounting the Switch

2-11