- ページ 9
スイッチ Cisco 300 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 300 Series 18 ページ。 Managed switches
Cisco 300 Series にも： データシート (14 ページ), クイック・スタート・マニュアル (17 ページ), クイック・スタート・マニュアル (17 ページ)
ページを印刷する
- 1. Quick Start Guide
- 2. Mounting the Cisco Switch
- 3. Rack-Mount Placement
- 4. Wall Mounting
- 5. Connecting Network Devices
- 6. Power over Ethernet (Poe) Considerations
- 7. Troubleshoot Your Connection
- 8. Front Panel Ports
- 9. Reset Button
- 10. Back Panel
- 11. Front Panel Leds
- 12. Returning the Device to the Factory Default Settings
- 13. Where to Go from here
Details on how to change the IP address on your computer
N
OTE
depend upon the type of architecture and operating system you are
using. Use the computer Help and Support functionality to search for "IP
Addressing."
Open a Web browser window. If you are prompted to install an
S
3
TEP
Active-X plug-in when connecting to the device, follow the
prompts to accept the plug-in.
Enter the switch IP address in the address bar and press Enter. For
S
4
TEP
example, http://192.168.1.254.
The Switch Login Page displays.
Enter the default login information:
S
5
TEP
•
Username is cisco
•
Default password is cisco (passwords are case sensitive)
If this is the first time that you have logged on with the default
S
6
TEP
username and password, the Change Password page opens. The
rules for constructing a new login and password are displayed on
the page. Enter a new administrator password and click Apply.
Make sure that any configuration changes made are saved to
C
AUTION
the Startup configuration before exiting from the web-based
interface by clicking on the Save icon. Exiting before you
save your configuration will result in all current changes
being lost the next time the switch is rebooted.
The Getting Started window displays. You are now ready to configure the
switch. Refer to the Cisco 300 Series Managed Switch Administration
Guide for further information.
Use the console port
To configure the switch by using the console port:
Connect a computer to the switch console port using the provided
S
1
TEP
serial cable.
Start a terminal application such as HyperTerminal on the
S
2
TEP
computer.
Configure the utility with the following parameters:
S
3
TEP
•
115200 bits per second (with release 1.2.5 of the firmware,
autobaud detection is enabled by default, so the switch should
detect the speed after you press Enter).
Cisco 300 Series Managed Switches
9