- ページ 4

スイッチ Cisco 3750 - Catalyst EMI SwitchのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 3750 - Catalyst EMI Switch 33 ページ。 Catalyst 3750 series switches
Cisco 3750 - Catalyst EMI Switch にも：データシート (18 ページ), インストールマニュアル (47 ページ), よくある質問 (10 ページ), 製品情報 (5 ページ), 製品サポート速報 (6 ページ), 製品概要 (25 ページ), 説明 (1 ページ), データシート (23 ページ), 製品サポート速報 (6 ページ), スタートマニュアル (27 ページ), データシート (23 ページ)

ページを印刷する

Cisco 3750 - Catalyst EMI Switch スタートマニュアル

Running Express Setup

When you first set up the switch, you should use Express Setup to enter the initial IP information.

Doing this enables the switch to connect to local routers and the Internet. You can then access the

switch through the IP address for further configuration.

To run Express Setup:

Verify that no devices are connected to the switch, because during Express Setup, the

Step 1

switch acts as a DHCP server. If your PC has a static IP address, before you begin you

should change your PC settings to temporarily use DHCP.

Step 2

Connect the AC power cord to the switch and to a grounded AC outlet. The power-on

self-test (POST) begins. During POST, the LEDs blink while a series of tests verify that the

switch functions properly.

Wait for the switch to complete POST. It might take several minutes for the switch to

Step 3

complete POST.

Verify that POST has completed by confirming that the SYST LED remains green. If the

Step 4

switch fails POST, the SYST LED turns amber.

POST errors are usually fatal. Call Cisco Systems immediately if your switch fails POST.

Press and hold the Mode button for

Step 5

3 seconds. When all of the LEDs

above the Mode button turn green,

release the Mode button.

If the LEDs above the Mode button

begin to blink after you press the

button, release it. Blinking LEDs

mean that the switch has already

been configured and cannot go into

Express Setup mode. For more

information, see the "Resetting the

Switch" section on page 23.

Verify that the switch is in Express Setup mode by confirming that all LEDs above the

Step 6

Mode button are green. (On some switch models, the RPS LED remains off.)

SY ST

RP S

M AS TR

ST AT

DU PL X

SP EE D

ST AC K

M O DE

Mode button

15 X

16 X