- ページ 10

スイッチ Cisco 400 SeriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 400 Series 40 ページ。 Fasthub 10/100 series
Cisco 400 Series にも：クイック・スタート・マニュアル (8 ページ)

Connecting APs

The setup instructions outlined in this document are for the

configuration shown in the diagram only. Your configuration may

differ, and the appropriate adjustments must be made.

1. From the main menu, click

2. Set the

Ethernet Multicast Mode

address that is currently not being used on your network for the

Multicast Group Address

3. Click the

button.

Apply

4. Click

Save Configuration

As the APs are connected to the network, they should automatically

find the controller via the CAPWAP discovery algorithms. The

Dynamic Host Configuration Protocol (DHCP) server will assign each

AP an IP address.

You can configure a DHCP server to run on a remote PC for a small

deployment. However, for large-scale deployments, an enterprise-

grade DHCP server must be used.

The

and

ap-manager

include the DHCP server you have configured. Alternately, you can

configure the DHCP server internally on the controller to hand out

leases to the connected clients. (Note: The WLC's DHCP server does

not lease addresses to the AP.) The instructions for doing so are

included at the end of this document.

1. From the main menu, click

VIEW Certified Configuration Guide

Controller.

Multicast

interfaces' configuration should

management

Controller

and enter a multicast IP

PN: 1725-36192-001_H