Cisco 400 Series 구성 매뉴얼 - 페이지 10
{카테고리_이름} Cisco 400 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 400 Series 40 페이지. Fasthub
10/100 series
Cisco 400 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지)
페이지 인쇄
Connecting APs
10
The setup instructions outlined in this document are for the
configuration shown in the diagram only. Your configuration may
differ, and the appropriate adjustments must be made.
1. From the main menu, click
2. Set the
Ethernet Multicast Mode
address that is currently not being used on your network for the
Multicast Group Address
3. Click the
button.
Apply
4. Click
Save Configuration
As the APs are connected to the network, they should automatically
find the controller via the CAPWAP discovery algorithms. The
Dynamic Host Configuration Protocol (DHCP) server will assign each
AP an IP address.
You can configure a DHCP server to run on a remote PC for a small
deployment. However, for large-scale deployments, an enterprise-
grade DHCP server must be used.
The
and
ap-manager
include the DHCP server you have configured. Alternately, you can
configure the DHCP server internally on the controller to hand out
leases to the connected clients. (Note: The WLC's DHCP server does
not lease addresses to the AP.) The instructions for doing so are
included at the end of this document.
1. From the main menu, click
VIEW Certified Configuration Guide
Controller.
to
Multicast
.
.
interfaces' configuration should
management
.
Controller
and enter a multicast IP
PN: 1725-36192-001_H