- ページ 42

スイッチ Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module ExpansionのPDF インストレーション・ノートをオンラインで閲覧またはダウンロードできます。Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 ページ。 Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion にも：インストレーション・ノート (14 ページ), 解決マニュアル (17 ページ), ホワイトペーパー (19 ページ), 説明 (1 ページ), 製品情報 (6 ページ), お知らせ (4 ページ), データシート (9 ページ), データシート (18 ページ), ホワイトペーパー (18 ページ), 設定マニュアル (8 ページ), インストレーション・ノート (28 ページ), トラブルシューティングマニュアル (11 ページ), インストレーション・ノート (18 ページ), ユーザーマニュアル (17 ページ), インストレーション・ノート (24 ページ), マニュアル (19 ページ), インストレーション・ノート (36 ページ)

Attaching Your ESD Grounding Strap

Figure 30

FAN

STATUS

Attaching Your ESD Grounding Strap

Electrostatic discharge (ESD) damage, which can occur when modules or other FRUs are improperly

handled, results in intermittent or complete failures. Modules consist of printed circuit boards that are

fixed in metal carriers. Electromagnetic interference (EMI) shielding and connectors are integral

components of the carrier. Although the metal carrier helps to protect the board from ESD, always use

an ESD grounding strap attached to a properly grounded bare metal surface when handling modules.

Follow these guidelines for preventing ESD damage:

•

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

Ejector Lever Closure in a Vertical Slot Chassis

All ejector levers flush

with module faceplate

Always use an ESD wrist strap and ensure that it makes maximum contact with bare skin. ESD

grounding straps are available with banana plugs, metal spring clips, or alligator clips. All

Catalyst 6500 series chassis are equipped with a banana plug connector (identified by the ground

symbol next to the connector) somewhere on the chassis front panel.

If you have an older Catalyst 6500 series chassis equipped with a plastic banana plug connector,

–

we recommend that you use either the supplied ESD grounding wrist strap (with a metal clip)

or an ESD grounding wrist strap equipped with an alligator clip.

If you have a newer Catalyst 6500 series chassis that has a bare metal hole as the banana plug

–

connector (also identified by the ground symbol next to the connector), we recommend that you

use a personal ESD grounding strap equipped with a banana plug.

If you choose to use the disposable ESD wrist strap supplied with the chassis or an ESD wrist strap

equipped with an alligator clip, you must attach the system ground lug to the chassis in order to

provide a proper grounding point for the ESD wrist strap.

78-15893-08