- ページ 16

スイッチ Cisco 9124 - mds multilayer fabric switchのPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 9124 - mds multilayer fabric switch 36 ページ。 Mds 9000 series
Cisco 9124 - mds multilayer fabric switch にも：仕様 (2 ページ), データシート (9 ページ), 仕様 (3 ページ), 設定マニュアル (49 ページ), リリースノート (48 ページ), リリースノート (44 ページ), リリースノート (36 ページ), リリースノート (22 ページ), リリースノート (3 ページ), リリースノート (40 ページ), マニュアル (16 ページ)

Installing the Switch in a Cabinet with Insufficient Front Clearance

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Insert the switch into the rack:

Step 2

By using both hands, position the switch with the back of the switch between the rear rack-mounting

rails as shown in

Note

Figure 2-11

Align the two C brackets on either side of the switch with the slider rails installed in the rack. Slide

the C brackets onto the slider rails and then gently slide the switch all the way into the rack. If the

switch does not slide easily, try realigning the C brackets on the slider rails.

Stabilize the switch in the rack by attaching the front rack-mount brackets to the rear rack-mounting

Step 3

rails:

Insert two screws (12-24 or 10-32, depending on rack type) through the holes in one of the front

rack-mount brackets and into the threaded holes in the back rack-mounting rail (see

For racks with square holes, first install the 12-24 cage nuts.

Note

Cisco MDS 9100 Series Hardware Installation Guide

2-16

Figure

2-11.

Figure 2-11

shows the front rack-mount brackets in a 180 degree position. Your front

rack-mount brackets may look different if you kept them in the normal position.

Sliding the Cisco MDS 9100 Series Switch (Rear-Facing) onto the Slider Rails

Rear cabinet

mounting

rails

Figure 2-12

shows the front rack-mount brackets in 180 degree position. Your front rack-mount

brackets may look different if you kept them in the normal position.

Chapter 2

Installing the Cisco MDS 9100 Series

Front cabinet

mounting

rails

Figure

2-12.)

OL-21514-01