- ページ 21

スイッチ Cisco ASR 920 seriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ASR 920 series 36 ページ。 Aggregation services router
Cisco ASR 920 series にも：設置マニュアル (36 ページ), はじめに (6 ページ), 設置マニュアル (42 ページ), ハードウェア・インストール・マニュアル (46 ページ)

Installing the Cisco ASR 920 Series Router

Connect to SFP Modules

This section describes how to connect to SFP modules.

Connect Fiber Optic SFP Modules

Caution

Do not remove the rubber plugs from the SFP module port or from the fiber optic cable until you are ready

to connect the cable. The plugs and caps protect the SFP module ports and cables from contamination and

ambient light.

Step 1

Remove the rubber plugs from the module port and fiber optic cable, and store them for future use.

Step 2

Insert one end of the fiber optic cable into the SFP module port.

Step 3

Insert the other end into a fiber optic connector at a target device.

Step 4

Observe the port's LED status.

The LED turns green when the device and the target device establish a link.

If the LED is off, check whether the target device is turned on, or whether there is any failure in the target device.

Step 5

If necessary, reconfigure and restart the device or target device.

Install the Chassis Ground Connection

Before you connect the power or turn on the power to the router, you must provide an adequate chassis ground

(earth) connection to your router.

This section describes how to ground the router chassis. The grounding lug location is on the back panel of

the router.

Tip

Ensure that the grounding lug wire does not cover the fan opening.

Figure 20: Attaching a Grounding Lug to the Rear of the Router

Grounding-lug

To ensure that the chassis ground connection that you provide is adequate, you need the following parts and

tools:

Connect to SFP Modules

Installing the Cisco ASR 920 Series Router