- ページ 4
コンピュータ・ハードウェア DIGISYNTHETIC DS216のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DIGISYNTHETIC DS216 10 ページ。 24-bit digital three crossover processor
Pressing the Encoder again, to enter into the Filter parameter "F" (Frequency) selection. Users are able
to select 24 ISO frequencies (rang:100Hz~20kHz) by rotating the Encoder clockwise or anti-clockwise.
if pressing the Encoder again, to enter into the Filter parameter "G" (Gain) adjusting. Users are able
to adjust "G" value from -12dB ~ + 12B (step is 1dB)by rotating the Encoder clockwise or anti-clockwise
if pressing the Encoder again, it will return to "FLT" status,
It is able to recycle such operation. If
(show as Fig.3).If press the PEQ key again, then return to
In short words, the step of Filter PEQ adjusting is following:
FLT
FLT
Press 8
Rotate 5
.
crossover parameter setting key. Firstly pressing the key to enter into HIGH-PASS Filter type
9 SETUP--
setting (show as Fig.4a)
Users are able to select 3 kinds of Filter curve types ("-12dB", "-18dB", "-24dB") by rotating Encoder
clockwise or anti-clockwise. At this time, if pressing Encoder, it is able to select the cut frequency
(Rang:20Hz
~20kHz)
3
press the PEQ key again, then the three Filters into FLAT status
CH:1 FLAT
F : 500Hz
Q
Press 5
Rotate 5
CH:1 HIGH-PASS
RESP/Q : -24dB
(show as Fig.4b).
CH:1 HIGH-PASS
FREQ: 20Hz
to adjust another Filter
PEQ status.(show as Fig.2)
Q:3.0
:+5dB
Fig.3
Q
F
Press 5
Rotate 5
FLAT
Fig.4a
Fig.4b
by rotating the Encoder also
F
G
Press 5
Rotate 5
G
Press 5
Press 8