DIGISYNTHETIC DS216 Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Комп'ютерне обладнання DIGISYNTHETIC DS216. DIGISYNTHETIC DS216 10 сторінок. 24-bit digital three crossover processor

Друкувати сторінку

Pressing the Encoder again, to enter into the Filter parameter "F" (Frequency) selection. Users are able

to select 24 ISO frequencies (rang:100Hz~20kHz) by rotating the Encoder clockwise or anti-clockwise.

if pressing the Encoder again, to enter into the Filter parameter "G" (Gain) adjusting. Users are able

to adjust "G" value from -12dB ~ + 12B (step is 1dB)by rotating the Encoder clockwise or anti-clockwise

if pressing the Encoder again, it will return to "FLT" status,

It is able to recycle such operation. If

(show as Fig.3).If press the PEQ key again, then return to

In short words, the step of Filter PEQ adjusting is following:

FLT

Press 8

Rotate 5

crossover parameter setting key. Firstly pressing the key to enter into HIGH-PASS Filter type

9 SETUP--

setting (show as Fig.4a)

Users are able to select 3 kinds of Filter curve types ("-12dB", "-18dB", "-24dB") by rotating Encoder

clockwise or anti-clockwise. At this time, if pressing Encoder, it is able to select the cut frequency

(Rang:20Hz

~20kHz)

press the PEQ key again, then the three Filters into FLAT status

CH:1 FLAT

F : 500Hz

Press 5

Rotate 5

CH:1 HIGH-PASS

RESP/Q : -24dB

(show as Fig.4b).

CH:1 HIGH-PASS

FREQ: 20Hz

to adjust another Filter

PEQ status.(show as Fig.2)

Q:3.0

:+5dB

Fig.3

Press 5

Rotate 5

FLAT

Fig.4a

Fig.4b

by rotating the Encoder also

Press 5

Rotate 5

Press 5

Press 8