- ページ 26

ステレオシステム Sharp CD-BA250HのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp CD-BA250H 42 ページ。 Mini component system
Sharp CD-BA250H にも：操作マニュアル (5 ページ), クイックマニュアル (4 ページ)

ページを印刷する

1. Speaker System

Using the Radio Data System (RDS) (continued)

„ Using the Auto Station Programme Mem-

ory (ASPM)

Whilst in the ASPM operation mode, the tuner will automatically search for new RDS

stations. Up to 40 stations can be stored.

If you have already stored some stations in memory, the number of new stations you

can store will be less.

Press the TUNER (BAND) button to select the FM band.

Press and hold down the ASPM button for at least 3 seconds.

After "ASPM" has flashed for about 4 seconds, scanning will start (87.50 -

108.00 MHz).

When an RDS station is found, "RDS" will appear for a short time and the sta-

tion will be stored in memory.

After scanning, the number of stations stored in memory will be displayed for

4 seconds, and then "END" will appear for 4 seconds.

E-20

ENGLISH

To stop the ASPM operation before it is complete:

Press the ASPM button whilst it is scanning for stations.

The stations which are already stored in memory will be kept there.

Notes:

z If the same station is broadcasting on different frequencies, the strongest fre-

quency will be stored in memory.

z Any station which has the same frequency as the one stored in memory will not be

stored.

z If 40 stations have already been stored in memory, the scan will be aborted. If you

want to redo the ASPM operation, erase the preset memory.

z If no stations have been stored in memory, "END" will appear for about 4 seconds.

z If the RDS signals are very weak, station names may not be stored in memory.

To erase all of the contents of preset memory:

1 Press the ON/STAND-BY button to enter the power stand-by mode.

2 Whilst pressing down the TUNER (BAND) button and the X-BASS/DEMO button,

press the ON/STAND-BY button until "TUNER CL" appears.

z After performing this operation, all of the preset memory information will be erased.

To store a station name again if the wrong name was stored in mem-

ory:

It may be impossible to store station names in memory using the ASPM function if

there is lots of noise or if the signal is too weak. In this case, perform as follows.

1 Press the

PRESET

names are correct.

2 If you find a wrong name during receiving the station. Wait until the correct name

will be displayed. And then press the MEMORY/SET button.

3 Within 30 seconds, press the MEMORY/SET button whilst the preset channel num-

ber is flashing.

z The new station name has been stored in memory correctly.

Notes:

z The same station name can be stored in different channels.

z In a certain area or during certain time periods, the station names may temporarily

be different.

PRESET

button to check whether the