ページを印刷する
Problem
The control panel does not work.
(Only for SJ-X510GP2,
SJ-X550GP2, SJ-X600GP2)
Some lines are on the surface of
the plastic parts.
Door alarm does not stop.
(Only for SJ-X510TP2,
SJ-X550TP2, SJ-X600TP2)
If you still require service
Refer to your nearest service agent approved by SHARP.
30
02_OM_TINS-C051CBRZ 21DT_EN.indd 30
02_OM_TINS-C051CBRZ 21DT_EN.indd 30
This may occur in one of the following cases.
• The panel or your fi nger is soiled with dripping, oil and etc.
• When you touch the panel with gloved hand, adhesive bandage on your
fi nger, nail or objects.
• Sticker or tape is affi xed on the keys.
• Touch position is slightly off from the keys.
• Operate time is not enough for the keys to work.
• These are not defects during production.
The meeting part of the resin material or
the junction part of the metallic mold are
remained like lines.
If the door alarm does not stop after closing all doors, it is a defect. Contact the
SHARP service center for service.
Method of stopping the door alarm temporarily
Press "R" button and "F" button simultaneously
and continuously for 3 seconds or more.
• The door alarm will sound again after
approximately 2 days.
Solution
Beep beep beep
Line
24/1/2565 BE 14:30
24/1/2565 BE 14:30