- ページ 9

自動車アクセサリー Digital Barriers EDGEVIS HD-IP450のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Digital Barriers EDGEVIS HD-IP450 16 ページ。

EDGEVIS HD-IP450 HARDWARE INSTALLATION GUIDE

Section 2 - Configuring communications on the HD-IP450

The HD-IP450 supports communications over 3G/4G cellular, Wi-Fi and

wired LAN connections. A cellular connection requires the insertion of a

valid SIM card. Each of the communication methods are set up using the

HD-IP450 web-interface Comms Settings page. More detailed

information on HD-IP450 set up can be found in the IP Series Setup Guide.

Connecting over a 3G/4G cellular network

A valid mobile SIM card is required in order to connect the HD-IP450 over a cellular communications bearer. The unit

has an inbuilt modem for 3G/4G connection with two 3G/4G antenna connectors on the front of the device. Note:

despite the ultra-efficient bandwidth usage achieved by TVI, the HD-IP450 is considered a heavy data use product on

cellular networks. It is recommended that an unlimited data plan (or if unavailable, a heavy consumption data plan) is

setup with your Mobile Network Service Provider for use with the HD-IP450.

To insert a SIM card, locate the SIM card slot on the front of the HD-IP450 unit and insert a standard SIM card into the

slot with the metal contacts facing upwards. To eject a SIM card, push the eject tab that is located to the left of the

SIM slot and slide out the SIM card. The network settings (for your Mobile Network Service Provider) are entered

during device setup – details of which are covered in Section 2 of the IP Series, HD-Q800, 4K-R800 - Setup Guide.

NOTE: Both the 3G/4G and MIMO antennas should be connected to obtain the best cellular signal and throughput.

Connecting over a Wi-Fi network

When using Wi-Fi as the communications bearer, ensure that a suitable Wi-Fi antenna is connected to the antenna

connector on the front plate. Details for the Wi-Fi connection must be entered during the device setup – details of

which are covered in Section 2 of the IP Series, HD-Q800, 4K-R800 - Setup Guide.

Connecting over a wired LAN connection

When using a wired LAN connection as the communications bearer, connect an Ethernet cable into one of the LAN

connector on the front of the HD-IP450. If all four LAN sockets are being used for IP cameras, then the supplied USB to

Ethernet adapter can be used as a communications bearer.

Details for the LAN connection must be entered during the device setup – details of which are covered in Section 2 of

the IP Series, HD-Q800, 4K-R800 - Setup Guide.

ISSUED: 10 NOVEMBER 2020

PAGE 9