- ページ 8

自動車アクセサリー Digital Barriers EDGEVIS HD-IP450のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Digital Barriers EDGEVIS HD-IP450 16 ページ。

EDGEVIS HD-IP450 HARDWARE INSTALLATION GUIDE

Storage medium

The HD-IP450 incorporates a removable storage bay for a solid-state disk (SSD) or hard disk drive (HDD). An SSD drive

is recommended for greater reliability, particularly if using the HD-IP450 for vehicle-based applications. The disk can

be removed when the unit is powered off. When powered on, the disk can be ejected using the IP Series local web

interface. From within this interface, click on Storage option, select the desired disk, and then use the Eject device

menu option.

Additionally, it is possible to use external USB disks to store recordings. For further details, refer to Section 2 of the IP

Series, HD-Q800, 4K-R800 - Setup Guide.

Updating the software on the unit

Once notified of a new software release by Digital Barriers, updates are available for download from the EdgeVis

support site (see below for link) for installation onto the device.

There are three ways to update the firmware:

•

To update remotely, upload the new firmware to the Firmware tab within the EdgeVis Server web interface

and then, from the Encoder tab, select Upgrade Firmware from the Select Action menu on the desired

encoder.

•

Using the Upgrade Firmware option when logged into the encoder's local web interface.

•

Copy the firmware onto a USB flash drive and insert into a USB port on the front of the unit. The flash drive

can be inserted into a running unit or before the unit is powered up. The update procedure will take

approximately ten seconds, and then the encoder will beep four times. At this point it is safe to remove the

pen and the unit will automatically reboot. If the update fails the encoder will beep continually.

To access or register for the Digital Barriers Support Site, visit

ISSUED: 10 NOVEMBER 2020

tvi-support.digitalbarriers.com

PAGE 8