Digital Barriers EDGEVIS HD-IP450 Installation Manual - Page 8
Browse online or download pdf Installation Manual for Automobile Accessories Digital Barriers EDGEVIS HD-IP450. Digital Barriers EDGEVIS HD-IP450 16 pages.
EDGEVIS HD-IP450 HARDWARE INSTALLATION GUIDE
Storage medium
The HD-IP450 incorporates a removable storage bay for a solid-state disk (SSD) or hard disk drive (HDD). An SSD drive
is recommended for greater reliability, particularly if using the HD-IP450 for vehicle-based applications. The disk can
be removed when the unit is powered off. When powered on, the disk can be ejected using the IP Series local web
interface. From within this interface, click on Storage option, select the desired disk, and then use the Eject device
menu option.
Additionally, it is possible to use external USB disks to store recordings. For further details, refer to Section 2 of the IP
Series, HD-Q800, 4K-R800 - Setup Guide.
Updating the software on the unit
Once notified of a new software release by Digital Barriers, updates are available for download from the EdgeVis
support site (see below for link) for installation onto the device.
There are three ways to update the firmware:
•
To update remotely, upload the new firmware to the Firmware tab within the EdgeVis Server web interface
and then, from the Encoder tab, select Upgrade Firmware from the Select Action menu on the desired
encoder.
•
Using the Upgrade Firmware option when logged into the encoder's local web interface.
•
Copy the firmware onto a USB flash drive and insert into a USB port on the front of the unit. The flash drive
can be inserted into a running unit or before the unit is powered up. The update procedure will take
approximately ten seconds, and then the encoder will beep four times. At this point it is safe to remove the
pen and the unit will automatically reboot. If the update fails the encoder will beep continually.
To access or register for the Digital Barriers Support Site, visit
ISSUED: 10 NOVEMBER 2020
tvi-support.digitalbarriers.com
PAGE 8