- ページ 6

制御システム Crestron IRP2のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Crestron IRP2 12 ページ。 Ir emitter probe
Crestron IRP2 にも：インストレーション・マニュアル (2 ページ), インストレーション・マニュアル (2 ページ)

Infrared Emitter

Package Contents

In addition to the IRP2, this package also contains an IR mask and two-

sided transparent tape.

Refer to the following instructions and illustration.

1. Identify the clear, flat bottom surface of the IRP2 shell.

2. Apply transparent silicon adhesive (not supplied) to the flat side of the

IRP2 or use the supplied transparent tape.

CAUTION: Test the silicon adhesive on a non-visible area to confirm

that it will not damage material or equipment.

3. Affix the IRP2 in the center of the IR sensor window on the front panel

of the controlled component.

4. Use a piece of non-damaging tape to hold the IRP2 in position while

the silicon adhesive cures.

5. Remove the tape after the silicon cures.

6. In some cases, identifying the exact location of the sensor window may

be difficult. Consult the owner manual of the unit, or the manufacturer

for the exact IR window location.

7. If the IRP2 shell must be removed and repositioned for any reason, be

sure to completely remove the silicon adhesive and repeat steps 1

through 5.

2 • Infrared Emitter

Crestron IRP2

Installation Guide – DOC. 8168A