Crestron IRP2 Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу для Системи управління Crestron IRP2. Crestron IRP2 12 сторінок. Ir emitter probe
Також для Crestron IRP2: Посібник з монтажу (2 сторінок), Посібник з монтажу (2 сторінок)
Друкувати сторінку
Infrared Emitter
Package Contents
In addition to the IRP2, this package also contains an IR mask and two-
sided transparent tape.
Installation
Attach the IRP2 to the IR Sensor Window
Refer to the following instructions and illustration.
1. Identify the clear, flat bottom surface of the IRP2 shell.
2. Apply transparent silicon adhesive (not supplied) to the flat side of the
IRP2 or use the supplied transparent tape.
CAUTION: Test the silicon adhesive on a non-visible area to confirm
that it will not damage material or equipment.
3. Affix the IRP2 in the center of the IR sensor window on the front panel
of the controlled component.
4. Use a piece of non-damaging tape to hold the IRP2 in position while
the silicon adhesive cures.
5. Remove the tape after the silicon cures.
6. In some cases, identifying the exact location of the sensor window may
be difficult. Consult the owner manual of the unit, or the manufacturer
for the exact IR window location.
7. If the IRP2 shell must be removed and repositioned for any reason, be
sure to completely remove the silicon adhesive and repeat steps 1
through 5.
2 • Infrared Emitter
Crestron IRP2
Installation Guide – DOC. 8168A