エンジン Crestron Electronics CSMI-QMTDC SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Crestron Electronics CSMI-QMTDC Series 9 ページ。 Replacement motor

CSM(I)-QMTDC Series Motor Replacement

Replacement Motor

The CSM(I)-QMTDC-163 series, CSM(I)-QMTDC-250 series, and CSM

(I)-QMTDC-275 series Crestron® shade motors can be easily removed and

replaced. The CSM(I)-QMTDC series replacement motors are used to

replace an existing shade motor.

In the Box

CSM(I)-QMTDC Series Motor, Replacement Motor

Motor Replacement

CAUTION:

Roll up the fabric to prevent damage while replacing the

motor.

NOTES:

A soft and clean work surface is required to perform this

procedure.

Remove the fascia and disconnect the motor cable before

performing this procedure.

Remove the Roller Shade Assembly from the

Mounting Brackets

1. Remove the old motor from the motor mounting bracket.

For a CSM(I)-QMTDC-163 series motor, press the release button

on the bottom of the shade motor.

For a CSM(I)-QMTDC-250 series or CSM(I)-QMTDC-275 series

motor, squeeze the two metal release clips next to the shade

motor.

2. Push the roller shade assembly towards the idler bracket to separate

the motor from the bracket. The idler pin compresses to allow the

motor end to swing out of the bracket.

3. Lift the idler end of the roller shade assembly and remove the idler pin

from the keyhole in the idler bracket.

4. Place the roller shade on a soft, clean surface where it will not be

damaged.

Remove the Old Motor from the Roller Tube

CAUTION:

Do not remove the motor by pulling on the control wire.

Remove a CSM(I)-QMTDC-163 or CSM(I)-QMTDC-250

Series Motor

Pull the motor head to remove it from the tube.

NOTES:

For CSM(I)-QMTDC-250 series motors:

Removing the motor may require a firm, hard pull.

If the motor is difficult to remove from the tube, reinstall the

motor latch and use it to help pull the motor from the tube.

Quick Start