- ページ 10

産業機器 Siemens SIPART PS2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SIPART PS2 28 ページ。 Mounting bracket kit
Siemens SIPART PS2 にも：インストール手順 (4 ページ), インストール手順 (4 ページ), ハードウェア・インストール・マニュアル (30 ページ), 技術説明 (26 ページ), コンパクト取扱説明書 (35 ページ), キット取り付け説明書 (9 ページ), インストール手順 (11 ページ)

Installing

3.2 Set of signs for the non-intrinsically safe version

3.2

Set of signs for the non-intrinsically safe version

Warning labels

Fasten the included warning label on the side across from the type plate. There are different

warning labels depending on the housing material, as described below.

Figure 3-1

Figure 3-2

Figure 3-3

3.3

Preparing for installation

Zone 2 and 22

It is not permissible to use the mechanical limit switch module in the zones 2 and 22.

To prepare the installation, proceed as follows:

1. Open the positioner.

2. To do this, loosen the four fixing screws of the housing cover with a Phillips screwdriver.

3. Disconnect the power supply cables or isolate them from power.

4. Remove the module cover.

5. To do this, remove the two screws with a screwdriver.

Warning label for a device with a plastic enclosure

Warning label for a device with an aluminum enclosure

Warning label for a device with a stainless steel enclosure

WARNING

SIPART PS2 with mechanical limit switch module

Operating Instructions (Compact), 04/2007, A5E01179056-01