- ページ 4

アクセサリー Digital Lumens DLA-RのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Digital Lumens DLA-R 8 ページ。

Step One: Install DLA Hardware

DL A-S Installation

2.1 in

5.3 cm

Important Note

The DLA-S is IP65-rated and designed for use in damp or wet

environments. Ensure that the included mounting gasket is

intact before installation.

METHOD ONE: CEILING INSTALLATION

a. Review the DLA-S dimensional drawings, above.

b. Remove and put aside the extra serial number label.

c. Remove the plastic bezel.

Hint: Squeeze the two flat areas on the edge of the bezel and

pull away to release.

d. Cut a .5 in (7 mm) or greater hole in the ceiling panel and run

the power and data wires through the opening.

e. Make power and data connections (see

f. Secure the housing using suitable fasteners (supplied by installer).

g. Replace the bezel.

METHOD TWO: 4-INCH IP65 JUNCTION BOX INSTALLATION

a. Review the DLA-S dimensional drawings, above

b. Remove and put aside the extra serial number label.

c. Remove the plastic bezel.

Hint: Squeeze the two flat areas on the edge of the bezel and

pull away to release.

d. Make power and data connections (see

e. Secure the housing to an IP65 round NEMA 4 or

weatherproof enclosure using the (2x) supplied Philips screws.

f. Replace the bezel.

4 | DL A SENSOR INSTALL ATION INSTRUCTIONS

4.9 in

12.4 cm

Step Two

on page 8).

Step Two

on page 6).

3.5 in

8.9 cm

Ceiling Mount

Junction Box Mount