Digital Lumens DLA-R 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Digital Lumens DLA-R에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Lumens DLA-R 8 페이지.

Step One: Install DLA Hardware

DL A-S Installation

2.1 in

5.3 cm

Important Note

The DLA-S is IP65-rated and designed for use in damp or wet

environments. Ensure that the included mounting gasket is

intact before installation.

METHOD ONE: CEILING INSTALLATION

a. Review the DLA-S dimensional drawings, above.

b. Remove and put aside the extra serial number label.

c. Remove the plastic bezel.

Hint: Squeeze the two flat areas on the edge of the bezel and

pull away to release.

d. Cut a .5 in (7 mm) or greater hole in the ceiling panel and run

the power and data wires through the opening.

e. Make power and data connections (see

f. Secure the housing using suitable fasteners (supplied by installer).

g. Replace the bezel.

METHOD TWO: 4-INCH IP65 JUNCTION BOX INSTALLATION

a. Review the DLA-S dimensional drawings, above

b. Remove and put aside the extra serial number label.

c. Remove the plastic bezel.

Hint: Squeeze the two flat areas on the edge of the bezel and

pull away to release.

d. Make power and data connections (see

e. Secure the housing to an IP65 round NEMA 4 or

weatherproof enclosure using the (2x) supplied Philips screws.

f. Replace the bezel.

4 | DL A SENSOR INSTALL ATION INSTRUCTIONS

4.9 in

12.4 cm

Step Two

on page 8).

Step Two

on page 6).

3.5 in

8.9 cm

Ceiling Mount

Junction Box Mount