- ページ 10

IP電話 Cisco Expansion Module 7914のPDF 電話マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Expansion Module 7914 33 ページ。 Expansion module cme
Cisco Expansion Module 7914 にも：システムマニュアル (50 ページ), システムマニュアル (36 ページ), マニュアル (33 ページ), クイック・スタート・マニュアル (2 ページ)

Position the phone so that the front of the phone is

Step 1

facing up.

Line up the two open slots on the bottom of the

Step 2

Expansion Module 7914 with the two hooks on the

support bar.

Insert the hooks into the slots and then rotate the top

Step 3

of the Expansion Module 7914 into the support bar so

that it rests flush with the bar.

Tighten the thumbscrew on the back of the

Step 4

Expansion Module 7914.

Note

Connect the Interface Cable

Refer to the following table, which depicts the "in" and "out"

icons on the AUX jacks, and to Figure 5 and the steps that

follow.

In icon

On your Cisco IP Phone or Expansion Module 7914,

Note

the AUX jack may be labelled RS-232. In this case read

"RS-232 jack" for AUX jack in Figure 5 and Steps 1 –

4 in this section.

If you are installing two Expansion Modules,

repeat Steps 2, 3, and 4 for the second

Expansion Module.

Out icon