- ページ 17
IP電話 Cisco IP DECT 6825のPDF ハードウェアのインストールをオンラインで閲覧またはダウンロードできます。Cisco IP DECT 6825 18 ページ。 Masergy
Cisco IP DECT 6825 にも: ユーザーマニュアル (17 ページ), ユーザーマニュアル (37 ページ), クイック・スタート・マニュアル (2 ページ), ユーザーマニュアル (7 ページ)
Hardware Installation
Charge the Handset Battery
You use the handset charger to charge the handset battery.
Note
The battery comes partially charged, but you should charge it for a minimum of 10 hours before you use it for
the first time. If you don't fully charge it, you may decrease the life of the battery.
If you remove and replace the battery from the handset, you need to fully discharge and then fully charge the
battery so that the battery indicator is accurate.
Caution
Charge the battery with the handset charger provided. If you use another method, you can damage the battery,
the handset, or your surrounding area.
Only charge the battery in environments where the temperature is between 32°F (0°C) and 104°F (40°C).
Caution
Do not charge the battery in hazardous environments or where there is explosion danger.
When you place the handset into the charger, it turns on (if not already on) and displays a message that the
handset is charging. The handset screen dims and turns off at the configured time.
If the LED on the handset starts to flash, the handset is updating its firmware.
Before you begin
Set up the cradle as described in
Ensure that your handset charger is plugged into the electrical outlet.
Procedure
Place the handset in the charger so that the contacts in the handset and the contacts in the charger match.
The handset screen should turn on and display a message that the handset is charging. If this doesn't happen,
remove the handset from the charger and try again.
Set Up the Charging Cradle, on page
Charge the Handset Battery
16.
Hardware Installation
17