Cisco IP DECT 6825 하드웨어 설치 - 페이지 17

{카테고리_이름} Cisco IP DECT 6825에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IP DECT 6825 18 페이지. Masergy
Cisco IP DECT 6825에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 사용자 설명서 (37 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (7 페이지)

페이지 인쇄

Hardware Installation

Charge the Handset Battery

You use the handset charger to charge the handset battery.

Note

The battery comes partially charged, but you should charge it for a minimum of 10 hours before you use it for

the first time. If you don't fully charge it, you may decrease the life of the battery.

If you remove and replace the battery from the handset, you need to fully discharge and then fully charge the

battery so that the battery indicator is accurate.

Caution

Charge the battery with the handset charger provided. If you use another method, you can damage the battery,

the handset, or your surrounding area.

Only charge the battery in environments where the temperature is between 32°F (0°C) and 104°F (40°C).

Caution

Do not charge the battery in hazardous environments or where there is explosion danger.

When you place the handset into the charger, it turns on (if not already on) and displays a message that the

handset is charging. The handset screen dims and turns off at the configured time.

If the LED on the handset starts to flash, the handset is updating its firmware.

Before you begin

Set up the cradle as described in

Ensure that your handset charger is plugged into the electrical outlet.

Procedure

Place the handset in the charger so that the contacts in the handset and the contacts in the charger match.

The handset screen should turn on and display a message that the handset is charging. If this doesn't happen,

remove the handset from the charger and try again.

Set Up the Charging Cradle, on page

Charge the Handset Battery

16.

Hardware Installation