Cisco IP DECT 6825 하드웨어 설치 - 페이지 5
{카테고리_이름} Cisco IP DECT 6825에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IP DECT 6825 18 페이지. Masergy
Cisco IP DECT 6825에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 사용자 설명서 (37 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (7 페이지)
페이지 인쇄
Hardware Installation
Install the Base Station
When the base station connects to the network, the LEDs light to indicate the network status:
• Green—Connected.
• Amber—Connection in progress.
• Red, flashing—Can't connect to the network.
• Red, solid—Network connection resetting.
Use this procedure to check that the base station and the network can communicate with each other, before
you mount the base station in the chosen location.
Before you begin
The base station requires:
• Power over Ethernet (PoE) or a power adapter
• LAN connection
• An IP address assigned by DHCP in the network
Procedure
Step 1
Plug one end of the Ethernet cable into the base station.
Step 2
Plug the other end of the Ethernet cable into the LAN port.
Step 3
If you don't use PoE, plug the power adapter into the base station and then into the electrical outlet.
Step 4
If the LED flashes red after a few minutes, do these steps:
a) Locate the Reset button on the bottom edge of the base station.
b) Press and hold Reset until the LED is a solid red.
c) Release Reset.
The LED should flash amber and then try to connect. If the LED doesn't light green, then the base station
can't get an IP address. See
What to do next
Mount the base station with one of these procedures:
•
•
•
Base Station LED is Solid Red
Mount the Base Station on the Ceiling, on page 6
Mount the Base Station on a Desk, on page 9
Mount the Base Station on the Wall, on page 10
Install the Base Station
for further help.
Hardware Installation
5