- ページ 12

プリンターアクセサリー Ricoh DDP 92のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ricoh DDP 92 23 ページ。 70e/92/184
Ricoh DDP 92 にも：パンフレット＆スペック (4 ページ), ユーザーマニュアル (20 ページ), プログラミング・マニュアル (40 ページ)

Chapter 2. General Information

If your Finisher is connected to a DDP 92, turn the finisher on and off using the switch

on the printer. The mark on the switch represents the binary characters "O" for off and

"I" for on.

If your Finisher is connected to a DDP 184, turn the finisher on and off using the Main

Power Switch. The mark on the switch represents the binary characters "O" for off and

"I" for on.

When the printer is powered on, the printer and the finisher go through a power-up

sequence that takes approximately 5 minutes. During the power-up sequence, the

printer will run a series of internal tests.

CAUTION:

Wait at least 5 seconds to power on the printer after powering off.

When the printer cannot be powered on, POWER OFF the printer and wait at least

30 seconds. Then power on the printer again.

F i n i s h e r F

Finisher

F i n i s

F i n i s h F i n i F I e r

Finisher

Main Power Switch

WARNING:

In the event of an emergency, POWER OFF the printer by turning the Power

Switch to'O' side. The printer can be always powered off by turning the Power

Switch to 'O' side.

O G

P o w e r

P O P o w e r

P P

P o w e r S w i t c h P o w e r S w i t c h

P o

0 0

Power Switch

2-1