Ricoh DDP 92 Kullanıcı Kılavuzu - Sayfa 12
Yazıcı Aksesuarları Ricoh DDP 92 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Ricoh DDP 92 23 sayfaları. 70e/92/184
Ayrıca Ricoh DDP 92 için: Broşür ve Teknik Özellikler (4 sayfalar), Kullanıcı Kılavuzu (20 sayfalar), Programlama Kılavuzu (40 sayfalar)
Sayfayı Yazdır
Chapter 2. General Information
2.1. Powering on the Finisher
If your Finisher is connected to a DDP 92, turn the finisher on and off using the switch
on the printer. The mark on the switch represents the binary characters "O" for off and
"I" for on.
If your Finisher is connected to a DDP 184, turn the finisher on and off using the Main
Power Switch. The mark on the switch represents the binary characters "O" for off and
"I" for on.
When the printer is powered on, the printer and the finisher go through a power-up
sequence that takes approximately 5 minutes. During the power-up sequence, the
printer will run a series of internal tests.
CAUTION:
Wait at least 5 seconds to power on the printer after powering off.
When the printer cannot be powered on, POWER OFF the printer and wait at least
30 seconds. Then power on the printer again.
F
F i n i s h e r F
Finisher
F i n i s
F i n i s h F i n i F I e r
Finisher
Main Power Switch
WARNING:
In the event of an emergency, POWER OFF the printer by turning the Power
Switch to'O' side. The printer can be always powered off by turning the Power
Switch to 'O' side.
O G
L
P o w e r
P O P o w e r
P P
P o w e r S w i t c h P o w e r S w i t c h
P o
0 0
Power Switch
2-1