- ページ 7

コントローラー ActronAir LR7-1GのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。ActronAir LR7-1G 8 ページ。

Installation Guide

4. Press the PROG button to accept changes. Display will show the zone CLOSE percentage and LOW. By default this will

be 0. Press the

NOTE

CLOSED and LOW range is 0-45%, with 5% increments per the

5. Press the PROG button to accept changes and return to the zone selection screen. Press the EXIT button to return to

Service Menu.

09. Advance Series Self-Learn Mode (EVV Indoor Models)

1. Ensure all connected zones have been detected or enabled.

2. Before activating, ensure the following:

• Return air filter, box and grille are properly installed.

• All doors or any other restrictions that may obstruct the air path back to the return and grille are open.

• Adjustable outlets should be in open position and System Air Balance should be complete.

1. System should be in the OFF MODE before activating self-learn mode.

2. Press and hold the

release.

3. Press the

4. AUTO will flash on the controller display during programming of self-learn mode.

NOTES

• If a self-learn passes PAS will display on the wall controller.

• If a self-learn fails, FAL will display on the wall controller.

• To return to Main Menu, press EXIT.

• To cancel Self-learn Mode, press

buttons to change value.

button and

button for 5 seconds or until the word Lrn appears on the display and

button once and release.

Note: Refer to Service Manual for troubleshooting.

button or EXIT.

LR7 Control Interface Insert

Doc. No. 9590-3019 Ver. 3 200702

LR7 Control Interface

buttons press.