- ページ 25

ネットワーク・ルーター Cisco 3640 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 3640 Series 37 ページ。 Rack-mount and wall-mount
Cisco 3640 Series にも：インストレーション・マニュアル (10 ページ), オーナーズマニュアル (17 ページ), ユーザーマニュアル (26 ページ), マニュアル (10 ページ), コンフィギュレーション・ノート (18 ページ)

Step 7

Exit from interface configuration mode.

yourname (config-if)#

Step 8

Enter interface configuration mode on an Ethernet interface for connection to your PC. The following example is for

Ethernet interface 0 in chassis slot 1.

yourname (config)#

yourname (config-if)#

Step 9

Configure IP address 10.10.10.1 on this interface.

yourname (config-if)# ip address 10.10.10.1 255.255.255.0

Step 10 Enter the no shutdown command to enable the interface.

Step 11 Exit from interface configuration mode.

yourname (config-if)#

Step 12 Save the configuration by entering the copy running-config startup-config command.

Step 13 Exit from configuration mode.

yourname (config)#

Step 14 Continue with the "Start SDM" section.

Start SDM

To start SDM and begin the router configuration, perform the following procedure:

Step 1

Connect the Ethernet port of the PC to the FastEthernet 0/0 port of the router, using a crossover cable. If there is no

Ethernet adapter in chassis slot 0 of the router, connect the PC to the Ethernet port that you configured in the section

"If Your Router Has No Ethernet Adapter in Slot 0."

Step 2

Open a web browser on the PC, and enter the following URL:

https://10.10.10.1/flash/sdm.shtml

Note

https://... specifies that the Secure Socket Layer (SSL) protocol is used for a secure connection. If SSL is not

available, you can use http://... .

Step 3

Enter the username sdm and the password sdm in the dialog box.

Step 4

A window appears informing you that Verisign certifies that this is a Cisco application. Click Yes, or click Grant to

accept the certificate and proceed. Additional certificate windows appear if you are using Netscape; click Grant to

accept the certificates.

The SDM Launch page appears after a short time. (See Figure 21.) Leave this window open and wait for the next

window.

exit

interface FastEthernet 1/0

exit