Cisco 3640 Series Snelstarthandleiding - Pagina 25
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco 3640 Series. Cisco 3640 Series 37 pagina's. Rack-mount and wall-mount
Ook voor Cisco 3640 Series: Installatiehandleiding (10 pagina's), Gebruikershandleiding (17 pagina's), Gebruikershandleiding (26 pagina's), Handmatig (10 pagina's), Configuratie Opmerking (18 pagina's)
![Cisco 3640 Series Snelstarthandleiding](/uploads/products/server2/542007/542007.png)
Step 7
Exit from interface configuration mode.
yourname (config-if)#
Step 8
Enter interface configuration mode on an Ethernet interface for connection to your PC. The following example is for
Ethernet interface 0 in chassis slot 1.
yourname (config)#
yourname (config-if)#
Step 9
Configure IP address 10.10.10.1 on this interface.
yourname (config-if)# ip address 10.10.10.1 255.255.255.0
Step 10 Enter the no shutdown command to enable the interface.
Step 11 Exit from interface configuration mode.
yourname (config-if)#
Step 12 Save the configuration by entering the copy running-config startup-config command.
Step 13 Exit from configuration mode.
yourname (config)#
Step 14 Continue with the "Start SDM" section.
Start SDM
To start SDM and begin the router configuration, perform the following procedure:
Step 1
Connect the Ethernet port of the PC to the FastEthernet 0/0 port of the router, using a crossover cable. If there is no
Ethernet adapter in chassis slot 0 of the router, connect the PC to the Ethernet port that you configured in the section
"If Your Router Has No Ethernet Adapter in Slot 0."
Step 2
Open a web browser on the PC, and enter the following URL:
https://10.10.10.1/flash/sdm.shtml
Note
https://... specifies that the Secure Socket Layer (SSL) protocol is used for a secure connection. If SSL is not
available, you can use http://... .
Step 3
Enter the username sdm and the password sdm in the dialog box.
Step 4
A window appears informing you that Verisign certifies that this is a Cisco application. Click Yes, or click Grant to
accept the certificate and proceed. Additional certificate windows appear if you are using Netscape; click Grant to
accept the certificates.
The SDM Launch page appears after a short time. (See Figure 21.) Leave this window open and wait for the next
window.
exit
interface FastEthernet 1/0
exit
exit
25