- ページ 8

自動車アクセサリー Acdeos AXS FLのPDF 凝縮マニュアルをオンラインで閲覧またはダウンロードできます。Acdeos AXS FL 17 ページ。 Fixed step
Acdeos AXS FL にも：インストール手順 (7 ページ)

Mechanical Installation of door switch: Find

the right place on the door to install the door

switch, preferably around the area in the

doorpost where you find the original door switch.

Make sure there is minimum around 10-12 mm

free space between the door and the door post

when the door is closed.

Drill a hole of 12.5 mm at the selected place.

The door switch is supplied as standard with the

cable loom.

Lead the cable with the door sensor through the

doorpost and stick the switch through the 12.5 mm hole

Place the Switch in the plastic holder. This is a tight fit.

You need to screw the holder around the switch.

1. Close the door. Measure the gap between the door and the door post. Adjust the switch

so, when installed, there is 7 mm of space between the switch and the door or 3 mm

between switch and magnet.

2. Push the switch + plastic holder in the drilled hole and fix / seal with a bit of PU glue.

3. Place the magnet on the opposite position on the door. Fix the magnet with a screw.

Check that magnet does not touch the switch

when door is closed with high speed and force

(slammed)

Careful, the Magnet is brittle. First drill the hole

and then fix the magnet with the screw just tight

enough to fix it. Fixing it too hard will damage the

magnet.

12.5mm