Acdeos AXS FL 요약된 매뉴얼 - 페이지 8

{카테고리_이름} Acdeos AXS FL에 대한 요약된 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acdeos AXS FL 17 페이지. Fixed step
Acdeos AXS FL에 대해서도 마찬가지입니다: 설치 지침 (7 페이지)

Mechanical Installation of door switch: Find

the right place on the door to install the door

switch, preferably around the area in the

doorpost where you find the original door switch.

Make sure there is minimum around 10-12 mm

free space between the door and the door post

when the door is closed.

Drill a hole of 12.5 mm at the selected place.

The door switch is supplied as standard with the

cable loom.

Lead the cable with the door sensor through the

doorpost and stick the switch through the 12.5 mm hole

Place the Switch in the plastic holder. This is a tight fit.

You need to screw the holder around the switch.

1. Close the door. Measure the gap between the door and the door post. Adjust the switch

so, when installed, there is 7 mm of space between the switch and the door or 3 mm

between switch and magnet.

2. Push the switch + plastic holder in the drilled hole and fix / seal with a bit of PU glue.

3. Place the magnet on the opposite position on the door. Fix the magnet with a screw.

Check that magnet does not touch the switch

when door is closed with high speed and force

(slammed)

Careful, the Magnet is brittle. First drill the hole

and then fix the magnet with the screw just tight

enough to fix it. Fixing it too hard will damage the

magnet.

12.5mm