- ページ 31

ネットワーク・ルーター Cisco Nexus 1000VのPDF 配備マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Nexus 1000V 49 ページ。 For microsoft hyper-v
Cisco Nexus 1000V にも：データシート (8 ページ), 配備マニュアル (25 ページ), マニュアル (6 ページ), 設置マニュアル (27 ページ)

ページを印刷する

Figure 26.

Network Segments

The network segment command is a new command introduced in the Cisco Nexus 1000V Switch for Microsoft

Hyper-V. Network segments are used to create Layer 2 networks on the VSM. In the first release of the Cisco

Nexus 1000V Switch for Microsoft Hyper-V, only VLAN-based network segments are supported. Other

segmentation technology is not supported in this release.

The Microsoft SCVMM networking model associates each network segment with a network site. When the network

segment is created on the VSM, the VSM administrator must also specify the network segment pool (network site)

to which the segment belongs. Figure 27 shows a network segment created using Vlan10. This network segment

can then be used by the Microsoft SCVMM administrator to create a DMZ virtual machine network.

Figure 27.

Note:

<id> command. The VSM administrator must use the nsm network segment command.

Note:

supported. Hence, the network segments switch-port mode must always be set to "access."

Applying an Uplink Port Profile to Server Uplink Interfaces During Logical Switch Creation

Creating a Network Segment

The Cisco Nexus 1000V Switch for Microsoft Hyper-V does not support VLAN creation using the vlan

In the first release of the Cisco Nexus 1000V Switch for Microsoft Hyper-V, trunk vEth interfaces are not

Page 31 of 48