Cisco Nexus 1000V Deployment Manual - Page 31
Browse online or download pdf Deployment Manual for Network Router Cisco Nexus 1000V. Cisco Nexus 1000V 49 pages. For microsoft hyper-v
Also for Cisco Nexus 1000V: Datasheet (8 pages), Deployment Manual (25 pages), Manual (6 pages), Installing Manual (27 pages)
Print Page
Figure 26.
Network Segments
The network segment command is a new command introduced in the Cisco Nexus 1000V Switch for Microsoft
Hyper-V. Network segments are used to create Layer 2 networks on the VSM. In the first release of the Cisco
Nexus 1000V Switch for Microsoft Hyper-V, only VLAN-based network segments are supported. Other
segmentation technology is not supported in this release.
The Microsoft SCVMM networking model associates each network segment with a network site. When the network
segment is created on the VSM, the VSM administrator must also specify the network segment pool (network site)
to which the segment belongs. Figure 27 shows a network segment created using Vlan10. This network segment
can then be used by the Microsoft SCVMM administrator to create a DMZ virtual machine network.
Figure 27.
Note:
<id> command. The VSM administrator must use the nsm network segment command.
Note:
supported. Hence, the network segments switch-port mode must always be set to "access."
© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Applying an Uplink Port Profile to Server Uplink Interfaces During Logical Switch Creation
Creating a Network Segment
The Cisco Nexus 1000V Switch for Microsoft Hyper-V does not support VLAN creation using the vlan
In the first release of the Cisco Nexus 1000V Switch for Microsoft Hyper-V, trunk vEth interfaces are not
Page 31 of 48