- ページ 9

ネットワーク・ルーター Cisco Nexus 9000 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Nexus 9000 Series 14 ページ。 Switch chassis
Cisco Nexus 9000 Series にも：クイックスタート設定マニュアル (6 ページ), 設定マニュアル (32 ページ), 設定マニュアル (32 ページ), マニュアル (30 ページ), インストレーション・マニュアル (12 ページ), インストール (8 ページ), マニュアル (16 ページ)

Installing the Chassis

c) Repeat Step 3 to attach the other slider rail to the other side of the rack.

To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count

the screw holes in the vertical mounting rails.

Step 4

Insert the switch into the rack and attach it as follows:

a) Holding the switch with both hands, position the two rear rack-mount brackets on the switch between the rack or

cabinet posts that do not have slider rails attached to them (see the following figure).

b) Align the two rear rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the

rack-mount guides onto the slider rails, and then gently slide the switch all the way into the rack until the front

rack-mount brackets come in contact with two rack or cabinet posts.

c) Holding the chassis level, insert screws (12-24 or 10-32, depending on the rack type) in each of the two front rack-mount

brackets (using a total of six screws) and into the cage nuts or threaded holes in the vertical rack-mounting rails (see

the following figure).

Installing the Switch Using the NXK-ACC-KIT-1RU Rack-Mount Kit

Installing the Chassis